Novel RPLC stationary phases for lipophilicity measurement: solvatochromic analysis of retention mechanisms for neutral and basic compounds

An RPLC was developed to rapidly determine lipophilicity of neutral and basic compounds using three base deactivated RPLC stationary phases particularly designed for the analysis of basic compounds, namely, Supelcosil ABZ(+)Plus, Discovery RP Amide C16, and Zorbax Extend C18. The work consisted of three sets of experiments. In the first log kw values of neutral compounds were extrapolated using hydroorganic mobile phases at different compositions. Good correlation between log kw and log Poct indicated that the method was appropriate for these supports, without adding a silanol masking agent. In the second set of experiments, isocratic log k values of neutral and basic compounds were measured with three different mobile phases. The best estimation of lipophilicity was obtained for neutral and basic compounds when the secondary interactions were strongly reduced (i. e., when basic compounds were under their neutral form). In the third set of experiments, isocratic retention factors of basic compounds (in their neutral form) were measured with a high-pH mobile phase, on a chemically stable support (Zorbax Extend C18). Under these chromatographic conditions, correlation between the isocratic retention factors and log Poct (log D10.5) for basic compounds was similar to that for neutral compounds.     

Comparison of slurry sampling and microwave-assisted digestion for calcium, magnesium, iron, copper and zinc determination in fish tissue samples by flame atomic absorption spectrometry

The development of a slurry sampling method for the determination of calcium, copper, iron, magnesium and zinc in fish tissue samples by flame atomic absorption spectrometry is described. In comparison with microwave-assisted digestion, the proposed method is simple, requires short time and eliminates total sample dissolution before analysis. Suspension medium was optimized for each analyte to obtain quantitative recoveries from fish tissue samples without matrix interferences. Nevertheless, iron recoveries higher than 46% were not found. Treatment of samples slurried in nitric acid by microwave irradiation for 15-30 s at 75-285 W permitted to achieve efficient recoveries for calcium, iron, magnesium and zinc. Further improvement in the matrix effects for iron determination was accomplished by the use of an additional step of short microwave-assisted suspension treatment. However, standard addition method was required for calcium and copper determination, being necessary hydrochloric acid as suspension medium for the last one. Although copper could not be determined in the certified reference material using microwave-assisted digestion, the accuracy of the slurry sampling method was verified for all the investigated analytes. Detection limits were 22.8 ± 8.0, 0.884 ± 0.092, 5.07 ± 0.76, 35.5 ± 0.7 and 1.17 ± 0.04 μg g⁻¹ for calcium, copper, iron, magnesium and zinc, respectively. The standard deviations obtained using slurry sampling method and microwave-assisted digestion were not significantly different, and the mean relative standard deviation of the over-all method (n = 3) of the slurry sampling method for different concentration levels was below 12%.     

PuH2气态分子热力学稳定性的理论研究

用密度泛函B3LYP方法计算了PuH2分子的微观性质、不同温度下气态PuH2分子的能量（E）、熵（S）及气态PuH2分子生成反应的标准焓变ΔH、标准熵变ΔS和标准自由能变ΔG.计算结果表明，气态PuH2分子不具有热力学稳定性.     

马来酸酐均聚反应机理的理论研究Ⅱ: α-羟基丁二酸酐碳阴离子和碱催化下的阴离子聚合机理

用AM1方法计算了马来酸酐、氢氧根阴离子及其加成物α-羟基丁二酸酐碳阴离子的电子结构、电荷分布和键级。应用前线轨道理论和成键三原则研究了碱(NaOH)催化条件下马来酸酐均聚过程中α-羟基丁二酸酐碳阴离子活性中间体参与反应的可能性及其阴离子聚合机理。计算结果能很好地阐明实验事实。     

Synthesis of porphyrin-appended terpyridine as a chemosensor for cadmium based on fluorescent enhancement

The design and synthesis of a porphyrin-appended terpyridine, 5-(4-([2,2′:6′,2″]-terpyridin-4-yl-carboxyamidyl)phenyl)-10,15,20-triphenylporphyrin (H₂TPPTPy) and its application as potential fluoroionophore for recognition of metal ions are reported. For preparation of the fluoroionophore, a novel simple strategy with improved total yield has been applied for the synthesis of 2,2′:6′,2″-terpyridine-4′-carboxylic acid as a ligand. H₂TPPTPy shows chelation-enhanced fluorescence effect with cadmium ion via the interruption of photoinduced electron transfer (PET) process, which has been utilized as the basis of the fabrication of the Cd(II)-sensitive fluorescent chemosensor. The analytical performance characteristics of the proposed Cd(II)-sensitive chemosensor were investigated. It shows a linear response toward Cd(II) in the concentration range of 3.2 × 10⁻⁶ to 3.2 × 10⁻⁴ M with a limit of detection of 1.2 × 10⁻⁶ M. The chemosensor shows good selectivity for Cd(II) over a large number of cations, such as alkali, alkali earth and transitional metal ions except Cu(II) and Zn(II). The sensor has been used for determination of Cd(II) in water samples with satisfactory recoveries.     

Determination of daidzein and genistein in soybean foods by automated on-line in-tube solid-phase microextraction coupled to high-performance liquid chromatography

An automated on-line method for the determination of the isoflavones, daidzein and genistein, was developed using in-tube solid-phase microextraction coupled to high-performance liquid chromatography (in-tube SPME-HPLC). In-tube SPME is a new extraction technique for organic compounds in aqueous samples, in which analytes are extracted from the sample directly into an open tubular capillary by repeated draw/eject cycles of sample solution. Daidzein, genistein and their glucosides tested in this study were clearly separated within 8 min by HPLC using an XDB-C8 column with diode array detection. In order to optimize the extraction of these compounds, several in-tube SPME parameters were examined. The glucosides daidzin and genistin were analyzed as aglycones after hydrolysis because the glucosides were not concentrated by in-tube SPME. The optimum extraction conditions for daidzein and genistein were obtained with 20 draw/eject cycles of 40 microl of sample using a Supel-Q porous layer open tubular capillary column. The extracted compounds were easily desorbed from the capillary by mobile phase flow, and carryover was not observed. Using the in-tube SPME-HPLC method, the calibration curves of these compounds were linear in the range 5-200 ng/ml, with a correlation coefficient above 0.9999 (n = 18), and the detection limits (S/N = 3) were 0.4-0.5 ng/ml. This method was successfully applied to the analysis of soybean foods without interference peaks. The recoveries of aglycones and glucosides spiked into food samples were above 97%.     

Application of heat conduction calorimetry to high explosives

This paper describes some thermal analysis experiments conducted on high explosive samples. These employ differential scanning calorimetry to monitor thermal effects at elevated temperatures (around 200 °C) and heat conduction calorimetry to record thermal effects at much lower temperatures (below 100 °C).The work shows that, due to the generally high thermal stability of many high explosive compositions, heat generation rates are very low, if detectable at all, at normal storage temperatures, even when using a very sensitive instrument. The sensitivity and reproducibility of this technique has been investigated in detail by Wilker et al. [S. Wilker, U. Ticmanis, G. Pantel, Detailed investigation of sensitivity and reproducibility of heat flow calorimetry, in: Proceedings of the 11th Symposium on Chemical Problems Connected with the Stability of Explosives, Sweden, 1998] and shown to be capable of recording heat generation rates of less than a microwatt. This allows continuous measurement of decomposition processes in nitrate ester based propellants at temperatures as low as 40 °C. However, the measurement of very low levels of heat generation is difficult, time consuming and therefore expensive. If the assumption is made that the life limiting process is invariably the slow decomposition of the energetic component, this will frequently lead to very long service lifetime predictions.A number of possible complications are identified. Firstly, due to its low detection threshold, a heat conduction calorimeter may detect other reactions which will not lead to failure, but which may still dominate the heat flow signal. Secondly, the true failure process may generate little energy and be overlooked. In view of these considerations, at present it seems unwise to rely on heat conduction microcalorimetry as the only tool for the assessment of the life of high explosive energetic systems.Based on examples of life terminating processes in high explosives during storage and use, it is clear that decomposition of the energetic material is not invariably the cause of system failure. It is also by no means the only reaction that may take place in, and be observed by, a heat conduction calorimeter.     

Ab initio through‐space/bond interaction analysis of the long C–C bonds in Bi(anthracene‐9,10‐dimethylene) photoisomers

The bi(anthracene‐9,10‐dimethylene) photoisomer has remarkably long C–C single bonds. To examine the lengthening of the C–C bond, we propose a novel procedure for quantitatively analyzing orbital interactions in a molecule at the level of the ab initio molecular orbital method. In this procedure, we can cut off the specific through‐space/bond interactions in a molecule by artificially increasing the absolute magnitude of the exponents in a Gaussian function. Then, the spatial orbital interactions were perfectly cut off, and, each term that makes up the total energy, that is, the nuclear–electron attractions, the electron–electron repulsions, and the nuclear–nuclear repulsions cancel each other. Several model molecules of the photoisomer were analyzed by this procedure. It was found that the orbital interaction between the p orbital on the benzene ring and the σ* orbital on the C–C bond in question, σ→σ* electron transfer through π orbital, weakens the C–C bond efficiently when these orbitals were located in the “periplanar” conformation. © 2001 John Wiley & Sons, Inc. Int J Quantum Chem, 2001     

Solventless injecction for packed column supercritical fluid chromatography

The adverse effects of injection solvent strength on microbore packed column SFC band broadening are demonstrated and a solventless injection system that eliminates these effects is introduced. The injection system removes solvent in a GC-like manner using a retention gap and an on-column capillary GC syringe. The analyte is delivered to the analytical column in a solvent-free plug of supercritical fluid mobile phase.     

A convergent synthesis of octadeca-2E, 13Z-dienyl acetate, a pheromone component ofSynanthedon tipuliformis C.

A convergent synthesis of octadeca-2E, 13Z-dienyl acetate, a pheromone component ofSynanthedon tipuliformis C., has been developed. The synthesis is based on cross-coupling of 8-iodooct-2E-en-I-ol THP ether with dec-5Z-enyl bromide catalyzed by CuBr. Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1529–1531, August, 1997.